Myalarm V-LCD1 Manual de Instruções descarregar pdf (Página 94)

100

101

LCD PROGRAMMING - AUXILIARY OUTPUTS

8-88

System 2 Installation / Programming Manual

As discussed above, various system events can be assigned to operate auxiliary outputs. Some

events will trigger outputs only locally on the unit on which they occur, while other events will trigger

outputs both on the unit they occur and on the master as well. Bear in mind, however, that the unit on

which an event occurs and the master may be one in the same unit (i.e., it happened on the master

and not on a slave).

If programmed to trigger outputs, events deemed important to system reliability or security (in our

opinion here at Corby) trigger both on the unit on which they occur and on the master. Other “lesser”

events trigger outputs only locally on the unit on which they occur.

The table below specifies the behavior of each of the triggerable events.

Event Type Local Only Both Master and Slave

System Reset X

AC Off X

AC On X

Door Ajar X

Door Closed X

Forced Entry X

Valid User X

Inv X

PIN Error X

Sched Error X

Request to Exit X

AP Error X

Door Perm X

Mem Clear X

Zone On X

Zone Off X

Slave Down X

Net Noise X

1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 335 336

Comentários a estes Manuais

Sem comentários

Myalarm V-LCD1 Manual de Instruções Página 94

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Myalarm V-LCD1