Myalarm V-LCD1 Manual de Instruções descarregar pdf (Página 114)

LCD PROGRAMMING - ADD/CHANGE DATA CHIPS

8-108

System 2 Installation / Programming Manual

Enter Number þþþþ

Enter Chip

Press Any Key þþþþ

Duplicate Code!

User Chips

If either Port is programmed for Data Chip, you will be prompted to enter a Data Chip Number.

If using Data Chips, you can either touch the Data Chip to the test point at the upper right hand

corner on the System 2 circuit board or use the optional Data Chip programming wand.

At this point, the LCD will scroll the following instructions:

Scrolling Options: Touch Data Chip

Enter Chip Number

Use Bckspc to correct

0=Quit

Be sure to “List Users” (Option 11 - Reports) after you have programmed all you Data Chips

into the System. If you wish to re-enter Data Chips, and you do not have them “in-hand”, you

must have the full 16-digit code. This code will print when you List Users. Since the code

contains alphanumeric characters a PC or VDT is also needed to re-enter these chips.

Note: If you were successful in entering your Data Chip, the actual Data Chip number will not

appear on the LCD, it will advance you to the next option which is Entering Additional Outputs.

Duplicate Code!

If you happen to attempt to enter a Chip which is already used, you will see the prompt:

Scrolling Options: 0=Quit

If this happens, simply select another chip or delete the existing chip.

For more information, see Delete a User.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 335 336

Sem comentários

Myalarm V-LCD1 Manual de Instruções Página 114