Myalarm V-LCD1 Manual de Instruções descarregar pdf (Página 27)

INSTALLATION

5-21

System 2 Installation / Programming Manual

CHAPTER 5

INSTALLATION

PLAN THE JOB

UNDERSTAND THE EQUIPMENT

READ THE MANUAL

This short section is included in this manual to aid you in analyzing the job requirements to ensure that the

System will perform to specifications and that the job will be completed successfully.

Mounting the System 2 Control Cabinet

The cabinet must be mounted in a dry secure area. It contains all the electronic circuits which control the

Keypad, Card Reader, Data Chip and locking mechanism. It is not waterproof. Mount the cabinet so the

LCD is easily accessible and visible, especially if this is going to be your only method of programming.

Corby supplies an actual size paper mounting template. Position the template in place and mark the exact

center of all four mounting screws. Installation is easier if you pre-drill the screw holes. Using #8 pan-head

screws, install the top two screws and tighten to within 1/16 in. (about the thickness of a penny). Hang the

System 2 on the top two screws and slide the System 2 down so the screws align in the cabinet slots. Install

the bottom two screws and tighten securely. Do not attempt to adjust or tighten the top two screws. The

cabinet contains ¾” and 1¾” knockout holes for installation of interconnect wires.

Caution: This product must be installed within the protected property.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 335 336

Sem comentários

Myalarm V-LCD1 Manual de Instruções Página 27