Myalarm V-LCD1 Manual de Instruções descarregar pdf (Página 220)

PC/VDT PROGRAMMING - BATCH ENROLL KEYPAD CODES

9-214

System 2 Installation / Programming Manual

The VDT will display the instructions:

01 03

Enter Door (0=Done)

The first line of the VDT will display the door(s) this group is allowed to access.

At the Enter Door (0=Done) [_ _] prompt, enter the next door this group is

allowed to access. When you are finished press 0 and ENTER. If you wish to change the door

permission at any time, reenter the number to deny access to a specified door.

Example: If you wish to “take door #3 permission away” from these users, enter door 3 again

and the permission will be denied.

If you select Port #3 or greater and you do not have this System set-up for networking, the

VDT will display:

Error!

Entry Out of Range!

Press Any Key

To enable more than two doors, the Networking Option needs to be installed. Proceed to

Option #13 for installation instructions.

When you are finished entering door numbers press 0.

Seed Number

What is a Seed Number? Here’s an example: You select a seed number of 1000, Batch Enroll

200 users, and use the System for months or years. One day, someone accidentally erases

memory. Now everyone’s codes are erased. No problem! When Batch Enrolling Users again,

simply select Seed Number 1000 again, and the System will assign the identical codes it did

previously, saving you time of issuing new numbers, and users the aggravation of memorizing a

new code number. Of course, you need to be sure to write down the seed number and store it in

a safe place for future use.

The Seed Number must be four digits. Again, you may not use Leading Zero’s.

The VDT will display the instructions:

Use 4 Digits

Enter Seed # [____]

1 2 ... 215 216 217 218 219 220 221 222 223 224 225 ... 335 336

Sem comentários

Myalarm V-LCD1 Manual de Instruções Página 220