Myalarm V-LCD1 Manual de Instruções descarregar pdf (Página 173)

PC/VDT PROGRAMMING

9-167

System 2 Installation / Programming Manual

CHAPTER 9

PROGRAMMING USING A VDT/PC

Introduction

When in program mode, instructions and prompts are displayed on the VDT and user responses are

entered on its Keyboard. Some basic features of program mode are:

Instructions are displayed indented from the left margin.

Prompts are displayed at the left margin.

Entering a 1 serves as YES when a Yes-or-No question is asked.

Entering a 2 serves as NO when a Yes-or-No question is asked.

The x is the clear key.

When entering a data item (like time, date etc.), the prompt line displays that item's current

setting. To change the current setting, just enter your desired data at the position indicated by

brackets

( [--]), then press ENTER. To leave the current setting unchanged, just press ENTER.

All System events which occur during programming will not be displayed (because you are

already using the VDT to program the system), but will be saved in the event buffer for later

retrieval if you so desire.

Keep it Simple

If you are new to the System 2, please do yourself a big favor: When it comes to installing or

programming this unit, "Please Keep it Simple". Until you really learn how this Electronic

Access Control System works, do only one thing at a time and then test it. Then, do the entire

installation that way. Thousands of hours and thousands of dollars have been lost by hundreds

of installers who just had to install and program everything "Right Now"... only to find out later

that they did it wrong and had to do it over.

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 335 336

Sem comentários

Myalarm V-LCD1 Manual de Instruções Página 173