Myalarm V-LCD1 Manual de Instruções descarregar pdf (Página 106)

LCD PROGRAMMING - ADD/CHANGE CARDS

8-100

System 2 Installation / Programming Manual

Error!! þþþþ

Press Any Key

Enter Number þþþþ

Enter Card [00000 _ _ _ _ _]

Enter Number þþþþ

Enter Card

[________________]

If you select Port #3 and you do not have this System set-up for networking, the LCD will

scroll:

Scrolling Options: Entry Out of Range!

To enable more than two doors, the Networking Option needs to be installed. Proceed to

Option #13 for installation instructions.

When you are finished entering door numbers press 0.

User Cards

If either Port is programmed for use with a reader, you will be prompted to enter a Card

Number.

Enter the Card Number shown on the Card’s label.

At this point, the LCD will scroll one of the following set of instructions:

If you chose card type 2 (Mag or Bar Code) the LCD will scroll:

Scrolling Options: 0=Quit

If you chose card type 5 (16 Digit Mag, Bar Code) the LCD will scroll:

Scrolling Options: 0=Quit

Wiegand and Proximity Cards have a facility code which needs to precede the five digit

Card Number. If you are programming either Wiegand or Proximity Cards and the facility

code is, for example, 07 and the five digit Card Number is 00024, simply enter 700024.

You now actually have a six digit Card Number - the facility code and the Card Number. If

the facility code is 10 or above, you will have a seven digit Card Number.

Bar Code and Mag-Stripe Readers do not require you to enter a facility code. If you are

programming either Bar Code or Mag-Stripe Cards and the code happens to be 00024,

simply enter 00024.

If you were successful in entering your Card Number, proceed to Entering Additional Outputs.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 335 336

Sem comentários

Myalarm V-LCD1 Manual de Instruções Página 106